The parameters have the following meaning:
Parameter Description Range of values / note
disable The transfer of BPDU packets is disa‐
bled for the port
Default: disabled
enable The transfer of BPDU packets is ena‐
bled for the port
-
Result
The BPDU transmit status is configured.
7.3.4.6 spanning-tree bpdu-receive
Description
With this command, you enable or disable the BPDU receive status at the port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdu-receive{enabled|disabled}
The parameters have the following meaning:
Parameter Description Range of values / note
enabled BPDU packets are received at the port Default: enabled
disabled BPDU packets are ignored at the port -
Result
The BPDU receive status is enabled or disabled.
Further notes
You can display the status of this function and other information with the show spanning-
tree interface command with the detail option.
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 329
To Next Page
Loading...
