11.3.5.2 vap security cipher (access point)
Description
With this command, you configure the encryption method for the WPA authentication.
Note
This command is available only in access point mode.
Note
iPCF, iPCF-HT or iPCF-MC mode activated
If iPCF, iPCF-HT or iPCF-MC mode is enabled, only "Open System" with the encryption
method AES is supported in the security settings with Security Context 1.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call up the command with the following parameters:
vap security cipher { auto | aes | tkip }
The parameters have the following meaning:
Parameter Description
auto TKIP or AES is used depending on the capability of the other station.
aes AES (Advanced Encryption Standard):
Strong symmetrical block encryption method based on the Rijndael algorithm that
further improves the functions of TKIP.
tkip TKIP (Temporal Key Integrity Protocol): A symmetrical encryption method with the
RC4 algorithm (Ron’s
Code 4). In contrast to the weak WEP encryption, TKIP uses changing keys de‐
rived from a main key.
Note
The encryption methods "WEP" and "TKIP" are not available with the transmission standards
"802.11n" and "802.11n only".
Result
The encryption method is configured.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 527
To Next Page
Loading...
Need help?
General
