Syntax
Call up help with the following parameters:
help [command]
Here, you replace [command] with the command for which you require help.
If the command for which you require help consists of several words, enter these words without
spaces.
Result
The syntax of the command is displayed.
Syntax
If you call up help without parameters, you will obtain a list of all permitted commands in the
current mode:
help
Result
The mode-specific as well as the global commands are displayed.
Note
Incomplete command names
If you have specified an incomplete command when calling help, a list of all commands that
start with the term you have entered is created.
2.7.5.2 The command "?"
Description
With this command, you call up the command list.
Syntax
Enter a question mark to obtain a list of all permitted commands in the current mode:
?
For this command, you do not need to press the enter key. The command executes
immediately after you type the character.
Description
2.7 General CLI commands
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
40 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
