7.1.1.22 show wlan ip-mapping
Description
This command shows the table for the IP mapping. The table contains the assignment of MAC
address and IP address of the SCALANCE W700 devices for which the client makes WLAN
access possible.
Note
This page is only available for clients or access points in client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show wlan ip-mapping
Result
The IP mapping table is displayed.
7.1.2 clear wlan statistics
Description
With this command, you reset the WLAN statistics.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
clear wlan statistics
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 203
To Next Page
Loading...
Need help?
General
