7.3.4.7 spanning-tree bpdu-transmit
Description
With this command, you enable or disable the BPDU transmit status at the port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdu-transmit{enabled|disabled}
The parameters have the following meaning:
Parameter Description Range of values / note
enabled BPDU packets are transmitted at the
port
Default: enabled
disabled BPDU packets are not transmitted at
the port
-
Result
The BPDU transmit status has switched over.
Further notes
You can display the status of this function and other information with the show spanning-
tree interface command with the detail option.
7.3.4.8 spanning-tree mst
Description
With this command, you configure the various properties of the Multiple Spanning Tree
function:
● With the cost option, you configure the port costs used to calculate the lowest-cost path.
● With the port-priority option, you configure the priority of the interface for negotiating
a Multiple Spanning Tree configuration.
● With the disable option, you disable the interface for the Multiple Spanning Tree function.
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
330 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
