7.1.7.4 wds connection over (access point)
Description
With this command, you specify the VAP interface via which the WDS connection is
established.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode for the WDS interface.
The command prompt is as follows:
cli (config-if-wdsX-0-Y)#
Syntax
Call up the command with the following parameters:
wds conncection over <vapX 0/Y>
The parameter has the following meaning:
Parameter Description Range of values / note
wdsX 0/Y Interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The VAP interface is set.
Further notes
You display the setting with the show wlan wds <wdsX 0/Y> command.
7.1.8 Commands in the force roaming configuration mode.
7.1.8.1 Introductory sentence for the force roaming configuration mode
this section describes commands that you can call up in the force roaming configuration mode.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 273
To Next Page
Loading...
Need help?
General
