11.2.1.1 show radius statistics
Description
This command shows the connection statistics from the RADIUS client to the RADIUS server.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
show radius statistics
Result
The connection statistics are displayed.
11.2.1.2 show radius server
Description
This command shows the RADIUS server configuration.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show radius server [<ucast_addr>]
The parameters have the following meaning:
Parameter Description Range of values / note
ucast_addr Value for an IPv4 unicast address Enter a valid unicast address
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Security and authentication
11.2 RADIUS client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
488 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
