7.1.1.7 show wlan basic
Description
This command displays the WLAN-basic configuration, for example, transmission standard,
frequency band.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan basic <wlan 0/X>
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The following WLAN settings are displayed:
● Admin status (whether the interface is switched on or off)
● Frequency band
● WLAN mode
● DFS (802.11h)
● Outdoor Mode
● Max Tx Power
● TX power check: Indicates whether the current WLAN settings of the selected country
violate the permitted transmit power restrictions.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
190 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
