The parameter has the following meaning:
Parameters Description Range of values / note
ms Length of the interval in milliseconds
(ms).
40 ... 1000
Default: 100
Result
The interval is specified.
Further notes
You show the set interval with the show wlan advanced <wlan 0/X> command.
7.1.5.24 wlan channel (Access Point)
Description
With this command, you specify the channel via which the access point communicates with
the client.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan channel { show-channels | <number(0=auto)> }
The parameters have the following meaning:
Parameters Description Range of values / note
show-channels Lists the available channels. --
number Channel number
If you want the access point to search
for a free channel itself, use "0".
Enter the channel number.
Default setting for both frequency
bands:
0 = Auto
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 229
To Next Page
Loading...
Need help?
General
