Siemens SCALANCE W738-1 M12 Configuration Guides

8.6.2.2 no snmpagent
Description
With this command, you disable the SNMP agent function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no snmpagent
Result
The SNMP agent function is disabled.
Further notes
You enable the SNMP agent function with the snmpagent command.
8.6.2.3 snmp agent version
Description
With this command, you configure whether all SNMP queries or only SNMPv3 queries are
processed.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp agent version {v3only|all}
Network protocols
8.6 SNMP
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
414 Configuration Manual, 09/2017, C79000-G8976-C324-08

Siemens SCALANCE W738-1 M12 Specifications

General

Brand	Siemens
Model	SCALANCE W738-1 M12
Category	Wireless Access Point
Language	English