11.5.4.1 ip access-group
Description
With this command, you enable the access control of the packets of a VLAN.
Note
The ACL rule applies to all ports that belong to the VLAN.
Requirement
● An IP access list has been created.
● The VLAN has a layer 3 interface.
● You are in the Interface configuration mode of VLAN
The command prompt is:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip access-group <access-list-number(1-20)> {in|out}
The parameters have the following meaning:
Parameter Description Range of values / note
access-list-
number
Number of the access control list 1 ... 20
in Specifies that incoming packets are fil‐
tered
-
out Specifies that outgoing packets are fil‐
tered
-
Result
The packets are filtered according to the access control list (ACL).
Further notes
You disable the setting with the no ip access-group command.
You display the configuration of the access control list with the show access-lists
command.
Security and authentication
11.5 IP access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
560 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
