The parameter has the following meaning:
Parameter Description Range of values / note
prefix Link local address Specify a valid link local address.
fe80::XXXX:XXXX:XXXX:XXXX
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The link local address is assigned to the interface.
Further notes
You delete the link local address with the no ipv6 address link-local command.
You display this setting and other information with the show ipv6 interface command.
8.2.4.8 no ipv6 address link-local
Description
With this command, you delete the link local address.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 address <prefix> link-local
The parameter has the following meaning:
Parameter Description Range of values / note
prefix Link local address Specify a valid link local address.
fe80::xxxx:xxxx:xxxx:xxxx
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
376 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
