Setting functions
8.2 Inverter control
Inverter with CU230P-2 Control Units
236 Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
This means that you can set the inverter
control in various ways
and toggle between
the settings. For instance, as described
above, the inverter can either be operated via
a fieldbus or via the terminal strip.
The settings in the inverter, which are
associated with a certain control type of the
inverter, are called
command data set.
You select the command data set using parameter p0810. To do this, you must interconnect
parameter p0810 with a control command of your choice, e.g. a digital input.
Figure 8-9 Example: Switching over the control via terminal strip to control via PROFIBUS or
PROFINET
An overview of all the parameters that belong to the command data sets is provided in the
List Manual.
Note
It takes approximately 4 ms to toggle between command data sets.
To Next Page
Loading...
