Installing
4.3 Installing Power Modules
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
47
Table 4- 3 Dimensions and clearances for the PM240
2)
2)
2)
3)
3)
3)
3)
3)
3)
Additional height with shield connection kit: FSA: +84 mm; FSB: +85 mm; FSC: +89 mm; FSD…FSF: +123 mm
You can mount the Power Modules without any lateral clearance up to an ambient temperature of 40 °C in operation.
For tolerance reasons, we recommend a lateral clearance of approx. 1 mm.
You can mount the Power Modules without any lateral clearance. For tolerance reasons, we recommend a lateral
clearance of approx. 1 mm.
4)
Total depth of the inverter: See below.
Table 4- 4 Mounting hardware for PM240
Table 4- 5 Dimensions and clearances for PM250
2)
3)
3)
FSE without filter 499 275 204 405 235 11 300 300 0
3)
3)
3)
3)
Additional height with shield connection kit: FSC: +89 mm; FSD…FSF: +123 mm
You can mount the Power Modules without any lateral clearance up to an ambient temperature of 40 °C in operation.
For tolerance reasons, we recommend a lateral clearance of approx. 1 mm.
)
You can mount the Power Modules without any lateral clearance. For tolerance reasons, we recommend a lateral
clearance of approx. 1 mm.
4)
Total depth of the inverter: See below.
To Next Page
Loading...
