Siemens SINAMICS G120 - Page 48

Installing
4.3 Installing Power Modules
Inverter with CU230P-2 Control Units
48 Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
Table 4- 6 Mounting hardware for PM250
Frame size
Material
Tightening torque
FSC
M5 screws
2.5 Nm
FSD, FSE
M6 screws
6 Nm
FSF
M8 screws
13 Nm
Table 4- 7 Dimensions and clearances for the PM260
Frame size
Dimensions (mm)
Clearances (mm)
Height
1)
Width
Depth
3)
a
b
c
Top
Bottom
Lateral
FSD without filter
419
275
204
325
235
11
300
300
0
2)
FSD with filter
512
275
204
419
235
11
300
300
0
2)
FSF without filter
634
350
316
598
300
11
350
350
0
2)
FSF with filter
934
350
316
899
300
11
350
350
0
2)
1)
Additional height with shield connection kit: +123 mm
2)
You can mount the Power Modules without any lateral clearance. For tolerance reasons, we recommend a lateral
clearance of approx. 1 mm.
3)
Overall depth of the inverter: See below.
Table 4- 8 Mounting hardware for the PM260
Frame size
Material
Tightening torque
FSD
M6 screws
6 Nm
FSF
M8 screws
13 Nm
Dimensions and drilling patterns for the PM330 GX Power Module with IP20 degree of protection
Installation material:
•
M8 screws, 15 Nm tightening
torque
Clearances:
•
30 mm at the side and front
•
200 mm at the top and bottom