Operation 4
Parking
1
6219_901-006
– Turn the battery isolation switch (1) anti-
clockwise up to the stop and into the "OFF"
position.
NOTE
Switch keys, FleetManager cards (variant),
FleetManager transponder chips (variant) and
the PIN code for access authorisation (variant)
must not be handed over to other persons
unless explicit instructions to this effect have
been given by the responsible fleet manager.
6219_003-145
1
2
3
Wheel chock (variant)
The wheel chock (variant) is used to prevent
the truck from rolling away on a slope. It is
located on the right-hand mudguard.
– Pull the latch forward (1) and hold it in place.
– Grip the wheel ch
ock by its handle (3).
Remove the wheel
chock from the support
mounting via the
guide (2).
– Push the wheel chock under a front axle
wheel on the side facing the descending
gradient.
– After use, reinsert the wheel chock in the
support mounting.
– Make sure that it i
s correctly seated in the
guide (2) and that
the latch (1) is holding the
wheel chock in pla
ce.
563
68011531 EN - 06/2019 - 02 161
To Next Page
Loading...
