Maintenance 5
General maintenance information
Maintenance - 3000 hours/every two years
At operating hours
Carried out
3000 6000 9000 12000 15000
Note
Perform all 1000-hour maintenance work.
Power unit
Change the gearbox oil in the drive wheel unit.
Replace the bleeder screws on the drive wheel units.
Hydraulics
Change the hydraulic oil.
Replace the return l
ine filter and the breather filter.
Variant: Replace the high-pressure filter.
1
Ordering spare parts and wearing
parts
DANGER
Risk of explosion!
If non-original parts are installed on
the truck, it is no longer approved for
use in potentially explosive areas!
Spare parts are provided by our spare parts
service department. The information required
for ordering parts can be found in the spare
parts list.
Only use spare parts as per the manufac-
turer's instructions. The use of unapproved
spare parts may result in an increased risk of
accidents due to insufficient quality or incor-
rect assignment. Anyone using unapproved
spare parts shall assume full responsibility in
the event of damage or harm.
NOTE
For explosion-protected trucks it is necessary
to specify the Miretti job number (1).
563
68011531 EN - 06/2019 - 02 369
To Next Page
Loading...
