4 Operation
Switching on
The "Automatic mast vertical positioning"
comfort feature consists of the following
individual functions:
• Display of the "Automatic mast vertical
positioning" feature
• Automatic startup of the "Auto
matic mast
vertical position" feature
Thetruckcanalsobefittedwithonlythe
display for the "lift mast tilt angle".
NOTE
Check the function of automatic mast vertical
positioning whenever the truck is used.
– Push the "automatic mast vertical position-
ing" softkey
.
The
symbol appears in the display.
– Tilt back the lift mast until it reaches the end
stop.
– Tilt the lift mast forwards.
The lift mast must stop in the vertical position.
The automatic mast vertical positioning can
be used.
– If the lift mast does not stop in the vertical
position, do not use the function.
– In this case, contact your authorised service
centre.
Switching on
Switching on using the key switch
WARNING
All checks and tasks required before daily use must
have been performed without any defects being
identified before switching on the truck.
– Perform the "visual inspections and functional
checks".
– Do not operate the truck if defects have been
detected; contact the authorised service centre.
116
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
