Operation 4
Traction
– Select the desired drive direction.
– Press the accelerator pedal.
The truck will travel in the sel
ected drive
direction.
NOTE
The drive direction can also be changed
during travel. Your foot can remain on the
accelerator pedal while you do so. The truck is
then decelerated and accelerated again in the
opposite direction (reversing).
NOTE
If an electrical fault occurs in the accelerator,
the drive unit is switched off. In this situation,
the truck is not electrically braked. Once the
electrical fault has been corrected, it will be
possible to drive the truck again by releasing
the accelerator pedal and then actuating
the accelerator pedal again. If the truck still
cannot be operated, park the truck securely
and contact the authorised service centre.
Starting drive mode, dual pedal
version (variant)
DANGER
Being trapped under a rolling or tipping truck could
cause fatal injuries!
–Sitonthedriver'sseat.
– Fasten the seat belt.
– Activate the available restraint systems.
– Observe the information in the chapter
entitled "Safety regulations when driving".
Thedriver'sseatisequippedwithaseat
switch. This seat switch checks whether the
driver's seat is occupied. If the driver's seat
is not occupied or if the seat switch is mal-
functioning, the truck cannot be moved and all
lifting functions are locked. In these situations,
the message
Sit in the driver’s seat
is shown on the display of the display-operat-
ing unit.
– Sit on the driver's seat. Fasten the seat belt.
563
68011531 EN - 06/2019 - 02 147
To Next Page
Loading...
