Still RX20-20L - Checking the condition and wear of the tyres

Maintenance 5
General maintenance information
Lubrication plan
A
B
C
D
Code
1
Lubrication point
(A)
Swing ax
le: two lubricating nipples on each side of the steering axle on the steeringarm
Steerin
g turntable: not present
(B) Sliding surfaces on the lift mast
(C)
Load chains
(D) One lubricating nipple on each of the two lift mast bearings
1
The respective lubricant specification can be found in the "Maintenance data table" section
below, under this Code.
This lubrication plan describes the series-production truck with standard equipment. For main-
tenance points on variant trucks, see the relevant chapter and/or instructions provided by the
manufacturer.
.
563
68011531 EN - 06/2019 - 02 371