Operation 4
Dynamic Load Control
DANGER
Risk of accident from a falling load!
The load may fall if the load centre of gravity has not
been taken into account or the load has not been
picked up securely.
– Pick up the load securely; see the chapter
entitled "Picking up loads".
CAUTION
If the weight determined by a load measurement
exceeds the permissible residual load capacity of
the truck, the truck cannot be operated safely.
– Set down and reduce the load immediately.
– If necessary, use another truck with sufficient
load-bearing capacity.
Tare function (variant)
The tare function is a variant of the precision
load measurement. The tare function ensures
that the load measurement records only the
load itself, and not the fork or the attachment.
This function is a sub-function of the "precision
load measurement" variant.
NOTE
During the following process, the fork carriage
must be lowered slightly. When doing so, the
fork must not touch the ground, as otherwise
the taring operation will be inaccurate.
– Set the lift mast t
overtical.
– Raise the fork to a height of between
300 mm and 800 mm.
– Press the button
.
The first menu le
vel appears.
– Press the "Load" softkey
.
– Press the "Precision load measurement"
softkey
.
563
68011531 EN - 06/2019 - 02 213
To Next Page
Loading...
