Maintenance 5
Safety regulations for maintenanc
e
– Observe the maximum lift height of the lift
mast and compare the dimensions listed in
the chapter entitled "Technical data" with
the dimensions of the hall in which the truck
is to be driven.
– Avoid collisions with the ceiling of the hall
and the resultant damage.
Working on the hydraulic equipment
The hydraulic system must be depressurised
prior to all work on the system.
Working on the electrical equipment
DANGER
Risk of explosion!
Work on the electrical
equipment
must only be performe
d outside
potentially explosi
ve areas and only
by a competent pers
on.
Any interference
with the electrical
equipment of the t
ruck is forbidden.
–Forworkontheel
ectrical equip-
ment, contact th
e authorised ser-
vice centre.
Safety devices
After maintenance and repair work, all safety
devices must be reinstalled and tested for
operational reliability.
Set values
The device-dependent set values must be
observed when making repairs and when
changing hydraulic and electrical compo-
nents. These are listed in the appropriate
sections.
563
68011531 EN - 06/2019 - 02 357
To Next Page
Loading...
