2 Safety
Emissions
Emissions
The values specified apply to a standard truck
(compare the specifications in the "Technical
data" chapter). Different tyres, lift masts,
additional units etc. may produce different
values.
Noise emissions
The values were determined based on
measuring procedures from the standard
EN 12053 "Safety of industrial trucks - Test
methods for measuring noise emissions",
based on EN 12001, EN ISO 3744 and the
requirements of EN ISO 4871.
This machine emits the fol
lowing sound
pressure level:
Continuous sound pressure level in the
driver's compartment
L
pAZ
Measurement
uncertainty K
pA
< 66.3 dB(A) 4 dB(A)
The values were dete
rmined in the test cycle
on an identical mach
ine from the weighted
values for operati
ng statuses and idling.
Time proportions:
• Lifting 18%
• Idling 58%
• Driving 24%
However, the indicated noise levels at the
truck cannot be used to determine the noise
emissionsat workplaces according to the most
recent version of Directive 2003/10/EC (daily
personal noise pollution). If necessary, these
noise emissions must be determined by the
operating company directly at the workplaces
under the actual conditions there (additional
noise sources, special application conditions,
sound reflections).
NOTE
Please observe the definition of the following
responsible person: "operating company".
66 5
6368011531 EN - 06/2019 - 02
To Next Page
Loading...
