4 Operation
Replacing and transporting the bat
tery
Replacing and transporting the battery
General information on replacing the
battery
DANGER
Risk of explosion!
Working on a truck within potentially
explosiveareas can lead to explosions
in the surrounding atmosphere.
No work must be performed on the
truck in potentially explosive areas!
– Only connect or disconnect
battery male connectors outside
of potentially explosive areas.
– Only change batteries outside of
potentially explosive areas.
CAUTION
Risk of components being damaged by the lifting
accessory and battery rolling away!
If the battery is not on a level, smooth floor with
sufficient load-bearing capacity, lifting accessories
andthebatterycanrollawayinanuncontrolled
manner.
– Follow the operating instructions for the lifting
accessories used.
– Always remove the battery on a level, smooth
floor with sufficient load capacity.
Batteries can be removed with a truck and
with a lift truck equipped with a battery change
frame.
The load cap
acity of the lifting accessory used
must at leas
t match the battery weight. See
the battery n
ameplate.
NOTE
Depending on the version, a potential equa-
lisation connection is present between the
battery tray and truck. When removing the
battery, this connection must be disconnected
at the potential equalisation point. The poten-
tial equalisation point is identified by the decal
information
.
324
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
