Operation 4
Handling the battery
the equalising charge begins between 6 and
24 hours after the end of the actual charging
process. The equalising charge takes up to
2 hours.
– Please refer to the operating instruc-
tions from the manufacturer of the battery
charger.
Ending the equalising charge
The equalising charge ends
automatically. If
the battery is required dur
ing this process, you
can interrupt the equalisi
ng charge by pushing
the "stop button" on the bat
tery charger.
– Please refer to the operating instruc-
tions from the manufacturer of the battery
charger.
CAUTION
Damage to the connection assembly is possible!
If you disconnect the charging cable while the bat-
tery charger is switched on, an arc will be produced.
This can lead to erosion at the contacts, which con-
siderably shortens the service life of the contacts.
– Switch off the battery charger before you discon-
nect the charging cable.
– Switch off the battery charger.
– Disconnect the battery male connector from
the plug for the battery charger.
– Insert the battery male connector fully into
the plug connection on the truck.
563
68011531 EN - 06/2019 - 02 323
To Next Page
Loading...
