2 Safety
Basic principles for safe operatio
n
○ Hazard warnings
○ Operating instructions
• Modifications must be designed
, checked
and implemented by a design offi
ce that
specialises in industrial tru
cks. The design
office must comply with the stan
dards and
directives valid at the time
that modifications
are made.
Decal information with the f
ollowing data must
be permanently affixed to the
truck so that it is
clearly visible:
• Type of modification
• Date of modification
• Name and address of the com
pany per-
forming the modifications
Changes to the overhead g
uard and
roof loads
DANGER
In the event of the overhead guard failing due to
a falling load or the truck tipping over, there are
potentially fatal consequences for the driver. There
is a risk to life!
Welding and drilling on the overhead guard chan-
ges the material characteristics and the structural
design of the overhead guard. Excessive forces
caused by falling loads or the truck tipping over may
result in buckling of the modified overhead guard
andnoprotectionforthedriver.
– Do not perform welding on the overhead guard.
– Do not perform drilling on the overhead guard.
CAUTION
Heavy roof loads damage the overhead guard!
To ensure the stability of the overhead guard at
all times, a roof load may only be mounted on the
overhead guard if the structural design has been
tested and the manufacturer has given approval.
– Seek advice from the authorised service centre
for the mounting of roof loads.
Warning regarding non-original parts
Original parts, attachments and accessories
are specially designed for this truck. We
44 5
6368011531 EN - 06/2019 - 02
To Next Page
Loading...
