4 Operation
Dynamic Load Control
NOTE
Please note the following special considerati-
ons:
•
If the load pressure sensor fails, the maxi-
mum load is assumed.
•
If the lifting stage switch fails, the maximum
lift height is assumed.
•
The authorised service centre can restrict
the "lifting" function.
Speed reduction when the fork
carriage is raised (variant)
If the truck is equipped with this variant, the
speed of the truck is reduced automatically
if the lift height of the fork carriage is above
500 mm.
1,6 t
2,71 m
7°
Load measurement (variant)
Knowing the weight of the load to be trans-
ported gives the driver greater security. If the
truck is equipped with the "load measurement"
comfort feature, the weight of the lifted load is
measured and displayed in the display-oper-
ating unit (1).
NOTE
The load measurement must be calibrated
in order to ensure accuracy at all times. The
"access authorisation for the fleet manager"
is required for the calibration. This access is
required:
•
After changing the fork arms,
•
After fitting or changing attachments,
•
If the displayed
values are obviously
incorrect.
– To calibrate the load measurement, contact
the authorised service centre.
– Observe the following safety information.
212
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
