Operation 4
Attachments
Picto-
gram
Attachment function
Adjust fork arms: open
Adjust fork arms: close
Rotate to the left
Rotate to the right
NOTE
The pictograms are affixed according to
the attachment fitted at the factory. If an
attachment with different functions is fitted,
the authorised service centre must check that
the pictograms bear the correct representation
and must change them if necessary.
A
B
C
D
1 2
3
4
Controlling attachments using the
Fingertip
In this version, the attachments (variant) are
controlled using the operating levers (1)
and (2). The adhesive label bearing the
pictograms for the hydraulic functions (3)
for the operating lever (2) and the adhesive
label (4) for the operating lever (1) are affixed
at the designated points.
– If the adhesive labels become illegible or
are missing, please contact your authorised
service centre.
– Observe the pictograms
for the attachment
functions on the adhesi
ve labels (3, 4).
The pictograms on the operating levers show
the respective functions that are activated by
these levers.
The following applies:
– Move the operating leve
r (1) in the direction
of the arrow (A) or (B).
The attachment moves accordingly in the
directions (A) or (B) as shown in the pictogram.
– Move the operating lever (2) in the direction
of the arrow (C) or (D).
The attachment moves a
ccordingly in the di-
rections (C) or (D) as s
hown in the pictogram.
563
68011531 EN - 06/2019 - 02 245
To Next Page
Loading...
