Operation 4
Replacing and transporting the bat
tery
Changing to a different battery type
Thetruckcanbeconvertedtoadifferent
battery type and capacity.
The new battery capacity and new battery type
must be set in the display-operating unit.
• If this is not done, the actual battery dis-
charge status cannot be determined. The
battery charge level is not displayed cor-
rectly.
• In the worst case scenario, d
eep discharge
can damage the battery.
Using his/her access authorisation, the fleet
manager can set the new battery capacity and
the new battery type in the display-operating
unit.
NOTE
When changing to TENSOR
®
batteries,
the authorised service centre must limit the
maximum speed of the truck to 17 km/h for
technical reasons.
Setting the new battery capacity and the
new battery type
–Stopthetruck.
– Actuate the parking brake.
– Press the button
.
– Press the "Settings" softkey
.
The first menu level appears.
– Activate the "Access authorisation for the
fleet manager".
The "Settings menu" opens on the display.
– Press the
Truck settings softkey .
– Press the
Battery softkey.
– Press the
Battery type softkey.
The possible batteries for the truck are listed
in the "Battery type" menu.
– Press the corresponding softkey for the
desired battery type.
563
68011531 EN - 06/2019 - 02 325
To Next Page
Loading...
