Operation 4
Replacing and transporting the bat
tery
6210_003-012
1
2
Transporting the lead-acid battery by
crane
DANGER
There is risk of fatal injury from being
struck by falling loads!
– Never walk or stand underneath
suspended loads.
The tray for the lead-acid battery (1) is
equipped with four lifting eyes. The battery
may only be transported by crane using a lift-
ing gear and bridge piece (2) that are suitable
in terms in size and load capacity.
– To avoid short circuits, cover batteries with
open terminals or connectors with a rubber
mat.
– Observe the operating instructions for the
lifting gear.
– Attach the battery (1) to suitable lifting gear
(2).
– Lift the battery carefully and ensure that it
hangs straight on the lifting gear.
The lifting gear must be vertical when lifting, so
that no lateral pressure is applied to the tray.
– Set the battery down carefully.
– Remove the lifting gear after the battery has
been set down.
– Do not place slack lifting gear on the battery
cells or allow it to fall on the battery cells.
563
68011531 EN - 06/2019 - 02 341
To Next Page
Loading...
