Operation 4
Cold store application
Operation
CAUTION
Changing from a cold internal temperature to
a warm outside temperature may result in the
formation of condensation water. This water may
freeze on re-entry to the cold store, blocking moving
parts of the truck.
It is essential that close attention is paid to the
duration of deployment in the different temperature
ranges for both types of application.
Before being used in the cold store, the truck must
be dry and warmed up.
The truck must not leave the cold store area for
more than 10 minutes. By adhering to this rule,
condensation water will not have time to form.
If the truck stays outside for more than 10 minutes,
it must remain there at least until the condensation
water has drained away and the truck has dried off.
Depending on the weather, this will take at least
30 minutes.
WARNING
Risk of injury!
If condensation water freezes in the cold store, do
not try to free parts that have become stuck with
your hands.
NOTE
During the warm-up phase, the hydraulic
power is limited to load program "1".
– To ensure operational safety, drive the truck
for approximately 5 minutes and actuate the
brake several times.
– Actuate all hydraulic lifting functions several
times.
This warm-up phase is necessary to ensure
that the oil reaches the operating temperature.
– Always park the truck outside the cold store.
CAUTION
Risk of component damage!
The lead-acid batteries must not be left in the cold
store overnight without power uptake or charging.
– Charge the battery outside the cold store
and operate the truck using a replacement
battery.
563
68011531 EN - 06/2019 - 02 283
To Next Page
Loading...
