5 Maintenance
Preserving operational readiness
7090_342-005
1
4
– The belt tongue (2) must release when the
red button (4) is pressed.
– The automatic blocking mecha
nism must
be tested at least once a year:
– Park the forklift truck on level ground.
– Pull out the belt with a jerk.
The automatic blocking mec
hanism must
block extension of the belt
.
– Tilt the seat at least 30 ° (if necessary,
remove the seat).
– Slowly extend the belt.
The automatic blocking m
echanism must
block extension of the be
lt.
Cleaning the seat belt
– Clean the seat belt as necessary, but
without using chemical cleaning materials
(a brush will suffice).
Replacement after an accident
As a rule, the seat belt must be changed after
an accident.
378
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
