Maintenance 5
Preserving operational readiness
• The protected areas are identified with
the decal information "ELECTRICALLY
CONDUCTIVE".
• Non-coated areas are labelled as follows:
"Non-conductive parts - risk o
f electrostatic
charge - only clean using a damp
cloth"
• The surface resistance must be less than
or equal to 1 GΩ (10
9
Ω) at a test voltage of
500 V
• Any damage to the paint layer must not
exceed a specified surface area.
Refer to the table below!
• For repairs, it is absolutely essential to use
antistatic paint made by the same manufac-
turer and with the same specifications.
Maximum permissible dama
ge to the surfaces
Category of the truck
Maximum permissible
damaged area
IIA
IIB
100 cm
2
IIB + H
2
IIB + C
2
H
2
IIB + H
2
+C
2
H
2
20 cm
2
– Please contact your authorised service
centre for repair or advice if you have any
questions.
563
68011531 EN - 06/2019 - 02 381
To Next Page
Loading...
