Maintenance 5
Preserving operational readiness
3
2
1
Checking the condition and wear of the
tyres
WARNING
Tyre quality affects the sta
bility and handling of the
truck.
Changes must only be made
following consultation
with the manufacturer.
When changing wheels or
tyres, ensure that this
does not cause the truc
ktotilttooneside(e.g.
always replace right-
hand and left-hand wheels at
thesametime).
– If necessary, remove
any foreign bodies (1)
embedded in the tyre t
read.
NOTE
The level of wear exhibited by tyres on the
same axle must be approximately the same.
Superelastic tyres and solid rubber tyres can
be worn down to the wear mark (2).
Checking wheel fastenings
– Check that the wheel-fastening screws (3)
of the drive axle and the wheel-fastening
nuts of the steering axle are securely in
place and re-tighten as necessary.
– Observe the torques specified in the "main-
tenance data table".
563
68011531 EN - 06/2019 - 02 385
To Next Page
Loading...
