Safety 2
Basic principles for safe operatio
n
• Tyres of inferior quality
• Changing rim wheel parts
• Combining rim wheel parts from
different
manufacturers
Therefore, the above-mentioned factors are
prohibited.
The following rules must be observed to
ensure stability:
– Only use tyres with equal and
permitted
levels of wear on the same axl
e.
– Only use wheels and tyres of the same type
on the same axle, e.g. only superelastic
tyres.
– Only use wheels and tyres approved by the
manufacturer.
– Only use high-quality pro
ducts.
Wheels and tyres approved by the manu-
facturer can be found on the spare parts list.
If other wheels or tyres are to be used, au-
thorisation from the manufacturer must be
obtained beforehand.
NOTE
Check with the authorised service centre
before changing over to a different tyre size.
When changing wheels or tyres, ensure
that the truck is not tilting. Always change
wheels on the right and left (e.g.) at the same
time. Changes must only be made following
consultation with the manufacturer.
If the type of tyre used on an axle is changed,
for example from superelastic tyres to pneu-
matic tyres, the load diagram must be changed
accordingly.
– Contact the authorised service centre
regarding this matter.
563
68011531 EN - 06/2019 - 02 47
To Next Page
Loading...
