User’s Manual
242 Reference / Window Overview
SHORTCUT
Use the Shortcut command to execute a shortcut, enable or disable a shortcut. The shortcut command can be
abbreviated to "SC".
NEO NOTES & TIPS: SC 2 - Execute shortcut 2.
NEO NOTES & TIPS: SC 2 disable - This will temporally stop the shortcut from being executed.
NEO NOTES & TIPS: SC 2 enable - This will re-enable shortcut 2.
TIMECODE
NEO now supports an internal timecode generator that can run independent of any media playback. To enable
internal timecode enable the option in the timecode tab of the "External Triggers" window.
TC RESET - This command will reset the internal timecode back to 00:00:00:00.
TC PAUSE - The internal timecode will stop in its current position.
TC CONtinue - Timecode will continue from where it was paused.
TC {time value} - Use this to set the timecode to a specific value.
NEO NOTES & TIPS: TC PAUSE - Pause the internal timecode at its current position.
NEO NOTES & TIPS: TC 00:20:03:15 - Set the timecode to 2 minutes, 3 seconds and 15 frames.
NEO NOTES & TIPS: TC CON - Start the internal timecode from a paused state.
TEMPO
The tempo command can be used to control the tap tempo functions of the software.
TEMPO RESET - Reset the tap tempo in the system.
TEMPO PAUSE - Temporarily pause the tap tempo events.
TEMPO CONtinue - Resume the paused tap tempo events.
TEMPO {value} - Set the tap tempo rate in bpm.
TEMPO DIV {value} - Divide the tempo by the specified amount.
2. Hardware Interfaces
External wings are dedicated hardware designed to provide hand on control to NEO. They include playback, shortcut,
and program devices.
CueServer
CueServer is a lighting control solution for of stand-alone architectural and show control. NEO is now able to directly
integrate with these products by exporting a cue list directly to the device. The CueServer tab will allow you to select
To Next Page
Loading...
