Command Pulldowns 37
NEO Lighting Control Console
Beam - sets selected fixtures to the default beam value.
Edge - sets selected fixtures to the default beam value.
Utility - sets selected fixtures to the default utility value.
NEO NOTES & TIPS: All fixture default values are set in the Fixture Library Editor per fixture type.
Command Pulldown - Release
Park - assign the current fixture value to a locked level. This
"park"ed level will keep the fixture at its current level, will not
change it as cues are activated and it will not be recorded at this
value.
Park Options
Un-park selected fixtures - will unpark all selected fixtures.
Un-park all fixtures - will unpark all fixtures.
Park allows the user to assign a level to a fixture that will not be
controlled by a cue. It places that fixture in stasis until it is
unparked. By default, all Parked fixtures shall not be recorded.
NEO NOTES & TIPS: This default is in System Properties>Show Defaults>Intermediate Options.
+
+
To Next Page
Loading...
