Stratasys Objet30 - Safety Features

Objet30 User Guide 2 Safety
DOC-34025 Rev. I 2-2
Safety Features
Stratasys 3D printers are designed to comply with CE and FCC
standards. They are equipped with the following safety features:
Interlock Switch
The power supplied to the UV lamp and the motion motors is
turned off when the cover is opened.
Warning
Do not defeat (override) the interlock switch. Doing so could
result in serious personal injury. If the interlock switch does not
function correctly, do not use the printer, and contact your
service provider.
Safety Lock
The cover is locked while the printer is working. The lock is
released when the printer reverts to pause or stop mode.
Warning
Do not defeat (override) the safety lock. Doing so could
result in serious personal injury. If the safety lock does not
function correctly, do not use the printer, and contact your
service provider.
UV Screening
The transparent section of the cover blocks harmful UV
radiation, allowing the operator to view models as they are being
made.
Circuit Breaker
The power to the printer is turned off in case of electrical
overcurrent.
Note: The circuit breaker is only accessible to service
personnel.
Grounded Chassis
The chassis of the printer is grounded, to prevent electrical
shock.
Note: The power outlet must be grounded in accordance with
the local electric code to provide this protection.