Objet30 User Guide 2 Safety
DOC-34025 Rev. I 2-6
Printer Operation
➢ This printer should not be installed in locations where children are likely to
be present.
Cette imprimante ne doit pas être installée dans des lieux pouvant accueillir
des enfants.
➢ The printer should only be operated by persons trained by an authorized
Stratasys representative.
➢ All persons operating or maintaining the printer should know the location of
first aid and emergency equipment and how to use it. Never block access
to this equipment.
➢ Keep fingers and other body parts clear of the printer when closing the
cover.
➢ Never attempt to open the printer while it is working.
➢ Never override the interlock safety switch.
➢ If the interlock safety switch ever fails, do not use the printer.
➢ Several parts of the printer remain extremely hot even after it has stopped
operating. Avoid touching the UV lamp and the print block.
UV Radiation
The UV lamp used in the printer emits dangerous radiation.
➢ If the UV lamp remains on when the printer cover is open, do not stare
directly at the UV light. Shut down the printer and call your Stratasys service
provider.
Printer Maintenance
➢ Service operations should be performed only by qualified personnel who
have been instructed in relevant safety precautions.
➢ Notify co-workers and those who have access to the printer before
beginning non-routine and hazardous work.
Report any potential dangers and safety-related accidents to your safety
officer or to other appropriate authorities.
To Next Page
Loading...
