Objet30 User Guide 5 Using Objet Studio
DOC-34025 Rev. I 5-25
Valid Object Placement
You can ensure that models do not overlap when you position them on the
build tray, and that they do not extend beyond the tray.
To ensure valid object placement:
1. From the Tools menu, select Constraints Settings.
Figure 5-20 Constraints Settings dialog box
2. Select Dynamic check to identify—
❒ invalid object placement while placing objects—On Drop selected.
❒ invalid object placement after moving objects—While Drag selected.
❒ objects placed beyond the tray’s boundaries—Outside Tray selected.
❒ objects that overlap—Object Collision selected.
Even if you do not use Dynamic Check when placing objects on the build
tray, Objet Studio automatically checks if there is a problem with the
positioning of objects on the tray before sending it to the printer. You can
also manually check for problems after positioning objects (see "Tray
Validation" on page 5-43).
Note: Remember that Objet Studio calculates the space occupied by an
object including the “bounding box” surrounding it (see Figure 5-33 on page 5-
35).
To Next Page
Loading...
