Objet30 User Guide 2 Safety
DOC-34025 Rev. I 2-9
Inhalation
Vapors from printing materials can be irritating to the respiratory system. If
respiratory irritation occurs, expose the victim to fresh air immediately.
➢ If the victim has stopped breathing, perform artificial respiration or
cardiopulmonary resuscitation.
➢ Seek medical attention immediately.
➢ Keep the victim warm but not hot.
➢ Never feed anything to an unconscious person.
➢ Oxygen should be administered by authorized personnel only.
Waste Disposal
Fully cured printed models can be disposed of as ordinary office trash.
However, special care is required when handling printer waste (uncured
printing material).
Printing Materials
➢ When removing the waste cartridge/container from the printer, wear
neoprene or nitrile gloves.
➢ To prevent liquid waste from splashing into the eyes, wear safety goggles.
➢ Liquid waste from the printer is classified as hazardous industrial waste.
Therefore, printing-material waste must be packaged and disposed of in a
manner that prevents human contact with it and contamination of water
sources.
➢ Empty Model-material and Support-material cartridges contain residue of
their contents. Some leakage of this residue may occur through the broken
cartridge seal. Therefore, handle and store empty cartridges with care.
➢ Do not attempt to reuse empty cartridges, and do not puncture them.
➢ Dispose of used cartridges and waste containers in accordance with local
regulations.
➢ Discard contaminated clothing, shoes, empty containers, etc., in
accordance with any applicable regulations.
To Next Page
Loading...
