Stratasys Objet30 - Converting CAD Files to SLC Format

Objet30 User Guide 3 Introducing the 3D Printer
DOC-34025 Rev. I 3-9
do this in GrabCAD Print or in a third-party STL-repair application (such as
Magics™, by Materialise
®
).
For more information, download From CAD to Objet Studio Workflow for
PolyJet Technology.
Converting CAD Files to SLC Format
When converting files to SLC format, it is recommended that you set a layer
thickness of 15 microns (0.015 mm). Since SLC files cannot be orientated in
Objet Studio, it is important that models are properly orientated before being
saved as SLC files. Considerations for suitable model orientation are explained
in "Manual Positioning" in Chapter 3 on page 5-22.