Objet30 User Guide 5 Using Objet Studio
DOC-34025 Rev. I 5-7
Group Purpose When
enabled
Tray
Settings
Ribbon
Model
Settings
Ribbon
Placing model files on
the build tray.
Always.
Pre-build/build
commands.
Models are on
the build tray.
Setting model
dimensions.
A model is
selected.
Cutting, copying,
pasting and deleting
models.
A model is
selected.
Moving, rotating and
resizing models.
A model is
selected.
Assigning model
finish and setting
support
strength/“hollow.”
A model is
selected.
Setting a model’s unit
of measure
(millimeters or
inches).
A model is
selected.
To quickly identify an icon, move the cursor over it to display a tooltip. The “Undo” and
“Redo” tooltips change to reflect your last Objet Studio action.
After activating some of the ribbon commands (by clicking them), they remain active
until you click another button or until you press the Escape key.
To Next Page
Loading...
