7.20 ANALOG INPUT WIRE-BREAK DETECTION (GROUP F4.3) ....................................
7.21 HOPPING FREQUENCY (GROUP F5.0) ....................................................................
7.22 BUILT-IN AUXILIARY TIMER (GROUP F5.1) ..............................................................
7.22.1 BASIC FUNCTIONS OF THE TIMER ............................................................
7.22.2 TRIGGER AND GATE CONTROL FUNCTION SETTING OF TIMER ............
7.22.3 CLOCK CONCATENATION FUNCTION SETTING OF TIMER .....................
7.22.4 CONCATENATION TRIGGER FUNCTION SETTING OF TIMER .................
7.23 BUILT-IN AUXILIARY COUNTER (GROUP F5.2) .......................................................
7.24 AUXILIARY FUNCTIONS (GROUP F5.3) ...................................................................
7.25 MOTOR TEMPERATURE DETECTION (GROUP F5.4) .............................................
7.26 MULTI-STAGE FREQUENCY SETTING (GROUP F6.0) ............................................
7.27 SIMPLE PROGRAMMABLE MULTI-STAGE OPERATION (GROUP F6.1).................
7.28 SWING FREQUENCY OPERATION (GROUP F6.2) ..................................................
7.29 PROCESS PID (4MS CONTROL CYCLE) (GROUP F7.0) .........................................
7.30 PROCESS PID MULTI-STAGE SETTING (GROUP F7.1) ..........................................
7.31 PROCESS PID SLEEPING FUNCTION (GROUP F7.2) .............................................
7.32 REVOLUTION SETTING AND FEEDBACK (GROUP F8.0) .......................................
7.33 REVOLUTION CLOSED-LOOP PARAMETER (GROUP F8.1)...................................
7.34 PROTECTIVE PARAMETERS (GROUP F8.2) ...........................................................
7.35 TORQUE CONTROL (GROUP F8.3) ..........................................................................
7.36 COMPENSATION PID (1MS CONTROL CYCLE) (GROUP F9.0) ..............................
7.37 PARAMETER SELECTION OF COMPENSATION PID CONTROLLER .....................
7.38 MODBUS FIELDBUS (GROUP FA.0) .........................................................................
7.39 MAPPING PARAMETER ACCESS (GROUP FA.1) ....................................................
7.40 COMMUNICATION LINKAGE SYNCHRONOUS CONTROL (GROUP FA.2) .............
7.41 EXPANSION MULTIFUNCTIONAL INPUT TERMINAL (GROUP FB.0 AND FB.1) .....
7.42 SERVO CONTROL AND SCALE POSITIONING (GROUP FB.2) ...............................
7.43 VIRTUAL INPUT AND OUTPUT (GROUP FF.0) .........................................................
7.44 PROTECTING FUNCTION CONFIGURATION PARAMETERS (GROUP FF.1) .........
7.45 CORRECTION PARAMETERS (GROUP FF.2) ..........................................................
7.46 SPECIAL FUNCTIONAL PARAMETERS (GROUP FF.3) ............................................
7.47 OTHER CONFIGURATION PARAMETERS (GROUP FF.4) .......................................
8. WARNING, ALARM DIAGNOSIS AND COUNTER MEASURES ....................................
8.1 TROUBLESHOOTING WITH WARNING OR ALARM DISPLAY ...................................
8.1.1 ALARM DISPLAY AND TROUBLESHOOTING ................................................
8.1.2 WARNING DISPLAY AND TROUBLESHOOTING ...........................................
151
151
152
152
153
153
154
154
155
158
160
164
164
168
173
173
173
176
177
178
181
182
183
183
184
186
186
189
190
190
192
192
194
194
194
199
To Next Page
Loading...
Need help?
General
