Terex Fuchs MHL380 D User Manual

4 DISPLAY AND CONTROL ELEMENTS
4.54 MHL380 D
The following maintenance work must be car-
ried out before each heating period:
►
Check glow plug (85/1) for burn-off and
replace if necessary.
►
Examine the fuel filter for clogging and
replace if necessary.
►
Check that electrical connections are se-
curely fastened.
►
Check that fuel lines and connections are
not leaking.
►
Check the air filter element for dirt.
If the heating does not come on, proceed as
follows:
►
Switch heating off.
►
Check fuses.
►
Switch heating on.
If the heating still does not function when
switched on for a third time, please contact
Eberspächer Customer Service. If you contin-
ue attempting to switch on the heating, the
system will be completely cut off and it will not
be possible to switch it back on again.
If the heating overheats:
Possible causes may be that the vents are
covered up or the suction intake grate is dirty.
►
Switch heating off.
►
Uncover vents.
►
Switch heating on.
Other malfunctions which cannot be remedied
by the operator must be checked and repaired
by Customer Service only.
MHL-XXXX-326
1
Fig. 85 Supplementary heating

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English