Terex Fuchs MHL380 D User Manual

7 CARE AND MAINTENANCE
7.54 MHL380 D
►
Unscrew the coolant drain plug (203/1) on
the cylinder block and drain off the coolant.
Collect the drained coolant in a suitable
container. Dispose of the coolant in com-
pliance with environmental regulations.
►
If necessary, rinse the cooling system with
clean water.
►
Reinstall coolant drain plug (203/1) on the
diesel engine.
►
Close the drain valve on the cooler (202/1).
►
Screw the protective cap onto the drain
valve (202/1).
►
Open the vent point (204/1) two turns.
►
Fill the cooling system with coolant.
h Chapter 66H3.15 67HFuels, lubricants and cool-
ants
Chapter 7.6.3.2 Checking the anti-
freeze.
►
Seal the cooler with the cap (201/1).
►
Close the vent point (204/1).
►
Start the diesel engine and allow it to run
for a short time. Always monitor the motor
temperature when the engine is running!
►
Stop the diesel engine and allow to cool
down. Check the coolant level and top up
(several times, if necessary). Check the
tightness of the cooling system.
►
Start the diesel engine and run it up to the
operating temperature.
►
Switch on the heating and allow it to heat
up.
►
Stop the diesel engine and allow to cool
down.
►
Perform venting at the vent point (204/1).
►
Check the coolant level and top up (several
times, if necessary).
►
Check the tightness of the cooling system.
ATTENTION
If the coolant level indicator
(205/38) lights up, bring the diesel
engine to idle immediately and then
turn it off.
Check the coolant level and top up
if necessary.
1
380-101-112
Fig. 203 Coolant drain plug on the cylinder block
1
380-101-112
Fig. 204 Vent point
MHL-NBXX-614
38
Fig. 205 Coolant level

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English