Troubleshooting
Topcon HiPer+ Operator’s Manual
5-12
The receiver’s Slot 3 is
turned off.
1. Connect your receiver and a
computer using an RS232 cable
(see “Establishing an RS232 Cable
Connection” on page 2-7).
2. Click Configuration->Receiver
->General.
3. In the Turn on/off Slots area,
enable the Slot 3 (B) check box.
The devices may be
out of acceptable radio
range.
• Verify that your devices are within
acceptable radio range.
• Move the devices within radio range.
Problem
Can see the icon for the receiver’s Bluetooth module on the
computer screen, but cannot connect to it.
Causes Solution
Device security
settings probably
differ.
• Make sure your Bluetooth enabled
devices use the same security
settings.
• See “Bluetooth Module
Configuration” on page 2-43,
specifically Figure 2-44 on page 2-
47 for details on changing security
settings.
Bluetooth module
settings may have
changed.
1. If you changed settings for your
Bluetooth module, remove it from
the list of discovered Bluetooth
devices using the Bluetooth
manager program (supplied with
the device used to manage the
receiver).
2. Repeat the search.
To Next Page
Loading...
