Bluetooth Problems
1-866-4TOPCON www.topconpositioning.com
5-11
The Bluetooth
module’s processor is
overloaded.
1. Put your receiver in Zero Power
Mode. See “Zero Power Mode” on
page 4-20 for details.
2. Press the Reset key for about one
second to return the receiver to
normal mode.
3. Re-connect to the Bluetooth
module.
The receiver does not
have a Bluetooth
module.
Contact your dealer to purchase a
Bluetooth enabled receiver.
Error Message
Open COM# port failed: Access is denied.
Causes Solution
Another application
uses the computer port
dedicated for
connection
• Close the application, then re-
connect.
• Connect the receiver via another,
unused computer port.
Problem
After searching for available devices, none are discovered.
Causes Solution
The receiver is not
receiving power.
• Check that the receiver is getting
power and is turned on.
• Check that the power cable is
attached to the correct serial port.
• Unplug the cable, then securely and
properly reconnect it to the receiver.
• If the power cable is damaged,
contact your Dealer to purchase a
new cable.
To Next Page
Loading...
