CHAPTER 4 TRANSMISSION SEQUENCE
B-EP Series
4-3
(2) Storing PC interface commands
NOTES: (1) The storage of PC commands is only performed if it is required.
(2) When the Format Command is not sent before storing the PC interface command
with the same number as the already stored PC command, memory will be used
with each storing.
(3) Performing other operations (storing PC interface commands and label issue
operation) after storing writable characters or logos automatically clears the
image buffer.
(4) Select commands to be stored as the occasion arises.
<New>
Format Command
Bit Map Font Data Command
No
Yes
(Add/change)
[ESC] J1: Formats flash memory.
Completion of
all storing
z Storing writable characters or logos
z Label issue o
eration
No
Yes
[ESC] XO: Declares the start of saving PC interface
commands.
Save Start Command
Label Size Set Command
Position Fine Adjust Command
Print Density Fine Adjust
Command
Image Buffer Clear Command
Line Format Command
Bit Map Font Format Command
Outline Font Format Command
Barcode/2-D Code Format Command
Save Terminate Command
[ESC] D: Sets the label size.
[ESC] AX: Adjusts the print position.
[ESC] AY: Adjusts the print density/separation setting.
[ESC] C: Clears the image buffer.
[ESC] LC: Sets the line format and draws it.
[ESC] PC: Sets the bit map font format.
[ESC] PV: Sets the outline font format.
[ESC] XB: Sets the barcode/2-D code format.
[ESC] RC: Draws data of the bit map font.
[ESC] XP: Declares the termination of saving PC
interface commands.
Mode Select Command
[ESC] M: Changes the print mode.
Power ON or
After linking to each interface
To Next Page
Loading...
Need help?
General