CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-2
8.2 OUTLINE OF COMMANDS
8.2.1 FORMAT OF INTERFACE COMMAND
Control codes are as listed below:
z ESC (1BH)
z GS (1DH)
z FS (1CH)
z HT (09H)
z LF (0AH)
z FF (0CH)
z CAN (18H)
8.2.2 HOW TO USE REFERENCE
Function Describes the outline of the function of the command.
Format Shows the format of the command.
The format designation method should conform to the following rules:
z n refers to a parameter item.
z Brackets and parentheses (e.g. [ ] or < >) are used only for description, and
must not be transmitted in practice.
z Other symbols must always be inserted at designated positions before being
transmitted.
Term Explains the term(s) used in the format.
Default value Default value of a parameter (at power-on or switching to ESC/POS mode)
Explanation Explains the command in detail.
Refer to Related commands
ESC Command
GS Command
FS Command
HT
LF
FF
CAN
To Next Page
Loading...
Need help?
General